Hitachi 61SDX01B - Manual (Page 46)

USING THE REMOTE TO CONTROL DVD FUNCTIONS
46
USING THE REMOTE TO CONTROL DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote
system of your DVD player. (refer to page 37 for precodes)
1. Turn ON your DVD player.
2. Aim the remote control at the front of your DVD player.
3. Press and release the DVD button to switch to DVD pre-coded mode.
4. Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown on
page 37. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct
two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player
does not turn off, try a different two digit preset code.
6. The remote will now control your DVD player.
NOTES:
1. If your DVD player cannot be operated after performing the above procedures, your DVD player code has not been