HP 1000C - Manual (Page 15)

Getting the Most Out of Your Printer 2-5
PRINTING ON THICK (0.3 mm)
CARDS
Caution: To print thick cards or cards requiring
straight paper path, use only the manual feed slot at
the back of the printer. The cards must be fed into
the printer individually.
1 . Insert the card against the side of the
manual feed slot, with the print side up.
Wait for the printer to grip the card before
releasing it.
2 . Push the tabs near the paper output slot
down until they lock in place. This will
allow the cards to exit from the printer
with a straight path.
3 . In HP’s print settings dialog box, click the
Setup tab and select the size and type of
the cards you are printing in the Paper
Size box; or, select Custom if none of the
sizes match the card size you are printing.
4 . Select Thick Plain Paper or Thick Glossary
Paper in the paper type box.
5. Check that Manual feed is selected in the
paper source box.
6 . Change any other print settings, if
necessary, and then click OK.
7. Proceed to print your cards.
Note: Remember to push the tabs back up into place
once the printing is completed.
PRINTING ON HP PREMIUM
TRANSPARENCY FILM AND SLIDES
Use only HP’s Premium Transparency Film, which is
specifically designed to work with your HP DeskJet
printer or other transparency film that is designed to
work with Inkjet printers.
1 . Extend the paper width and length
adjusters to the maximum.
2 . Insert HP Premium Transparency Film with
the rough side down and the adhesive
strip facing inward in the paper tray.
3 . Slide the paper width and length adjusters
in until they press lightly against the
transparency.
PROFESSIONAL SERIES H
2
1
Chapter2 Page 5 Tuesday, March 18, 1997 7:16 PM