HP 1000C - Manual (Page 8)

1-4 Getting Started
STEP 5: Loading Paper
The HP DeskJet 1000C printer prints on plain paper
and most other types of paper. Most plain paper
used for photocopying yields good results. See page
4-2, “Recommended Printable Weight” for
information on other paper types you can use. See
also pages 2-2 through 2-4 for information on
loading other size paper, envelopes, labels and thick
paper.
Main Bottom Media Tray
1. Raised the output tray and extend the
paper width and length adjusters to the
maximum.
2. Insert up to
3
/ 5 inch (15 mm) stack of paper
aligning the right edge of the paper stack
against the right side of the In-Tray, print
side down. Slide the paper in until it stops.
3. Slide the paper width and length adjusters
in until they press lightly against the paper
stack.
4. Lower the output tray to its horizontal
position.
Alternative Top Media Feed
1. Extend the paper width and length
adjusters to the maximum.
2. Insert up to a maximum of 10 sheets of
paper aligning the right edge of the paper
stack against the right side of the tray,
print side down. Slide the paper in until it
stops.
3. Slide the paper width adjuster in until it
presses lightly against the paper stack.
Note: You do not need to remove paper from the
main bottom tray when you use the alternative feed.
The printer will check for paper feeding from the
alternative media feed. If paper is detected, the
printer will pick paper from there without checking
the main tray.
STEP 5
PROFESSIONAL SERIES H
PROFESSIONAL SERIES H
PROFESSIONAL SERIES H
PROFESSI ONAL SERIE S H
PROFESSI ONAL SERI ES H
PROFESSIONAL SERIES H
1
2
3
1
2
3
Chapter1 Page 4 Friday, March 14, 1997 9:42 AM