Hoshizaki KM-901MWH User Manual

Page 63

Advertising
background image

63

Problem

Possible Cause

Remedy

[7] Fan motor will

not start, or is not
operating (except
water-cooled model).

a) Fan Motor

1. Motor winding open.

1. Replace.

2. Bearing worn out.

2. Replace.

3. Wiring to fan motor.

3. Check for loose connection

or open, and replace.

4. Defective capacitor.

4. Replace.

5. Fan blade bound.

5. Check and replace.

b) Control Board

1. Defective.

1. See "IV.B. Control Board

Check."

[8] All components

run, but no ice is
produced.

a) Refrigerant

1. Low charge.

1. Check for leaks. Recover,

repair, evacuate, and
recharge.

2. Air or moisture

trapped.

2. Recover, replace drier,

evacuate, and recharge.

b) Compressor

1. Defective.

1. Replace.

c) Hot Gas Valve

1. Continues to open in

freeze cycle.

1. Check and replace.

d) Liquid Line Valve

(if applicable)

1. Continues to close in

freeze cycle.

1. Check and replace.

e) Inlet Water Valve

1. Inlet water valve is

wide open during
freeze.

1. Check for water leaks with

icemaker off.

f) Expansion Valve

1. Bulb loose.

1. Secure bulb.

2. Operating erratically.

2. Check and replace.

g) Headmaster (C.P.R.)

(remote condenser
unit)

1. Not operating properly

and liquid line
temperature too warm.

1. Replace headmaster.

h) Water Supply Line

(water-cooled model)

1. Condenser water

pressure too low or
off and high pressure
control opens and
closes frequently.

1. Check and get

recommended pressure.

i) Water Regulating Valve

(water-cooled model)

1. Set too high.

1. Adjust or replace. See

"V.J. Adjustment of Water
Regulating Valve."

2. Evaporator is Frozen Up

Problem

Possible Cause

Remedy

[1]Freeze cycle time is

too long.

a) Inlet Water Valve

1. Diaphragm does not

close.

1. Check for water leaks with

icemaker off.

b) Float Switch

1. Float does not move

freely or defective
switch.

1. Clean or replace. See "IV.

D. Float Switch Check and
Cleaning."

c) Evaporator

1. Scaled up.

1. Clean.

2. Damaged.

2. Replace.

d) Spray Tubes

1. Dirty.

1. Clean.

2. Out of position.

2. Place in position.

e) Pump Motor

1. RPM too slow.

1. See chart 1.[5].

Advertising
This manual is related to the following products: