HP 5300 - Manual (Page 132)

HP Smart Array 5300 Controller User Guide G-1
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: q-appg POST messages
Codename: SilverHammer Part Number: 135606-005 Last Saved On: 10/8/02 11:26 AM
G
POST Error Messages
Smart Array controllers produce diagnostic error messages at reboot. Many of these
Power-On Self-Test (POST) messages are self-explanatory and suggest corrective
actions for troubleshooting. Detailed information about these messages is given in
Table G-1.
Table G-1: POST Error Messages
Message Description Meaning and Recommended Action
1702 SCSI cable error detected. System
halted. There is a termination or cabling problem
with the system board integrated SCSI
controller. See the cabling information in
this guide.
1711 Slot x drive array – RAID ADG logical
drives present but cache size is less
than or equal to 32 MB. This configuration is not recommended.
Migrate the logical drive (or drives) to RAID
5 or upgrade the array accelerator cache
module.
1712 Slot x drive array – RAID 5 logical
drives present with 56 drives or more,
but cache size is less than or equal to
32 MB. This configuration is not recommended.
Migrate the logical drive (or drives) to RAID
0 or 1, reduce the number of drives in the
array, or upgrade the array accelerator
cache module.
1713 Slot x drive array – Redundant ROM
reprogramming failure. Replace the controller if this error persists
after restarting the system.
1714 Slot x drive array – Redundant ROM
checksum error. Backup ROM has been activated
automatically. Check the firmware version.
continued