HP 5300 - Manual (Page 142)

POST Error Messages
HP Smart Array 5300 Controller User Guide G-11
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: q-appg POST messages
Codename: SilverHammer Part Number: 135606-005 Last Saved On: 10/8/02 11:26 AM
Table G-1: POST Error Messages continued
Message Description Meaning and Recommended Action
1793 Slot x drive array – array accelerator
battery depleted. Data in array
accelerator has been lost. (Error
message 1794 is also displayed.) While the system was in use, power was
interrupted while data was in the array
accelerator memory. Power was not
restored within four days, so the batteries
were depleted and data in the array
accelerator was lost. Check all files for
potential data corruption.
-or-
The array accelerator batteries have failed.
1794 Slot x drive array – array accelerator
battery charge low. Array accelerator is
temporarily disabled. Array accelerator
will be re-enabled when battery
reaches 90% charge.
If the battery pack has failed, this
message will also be displayed:
Array accelerator batteries have failed
to charge and should be replaced
(Spare PN 120978-001)
The battery charge is below 90%. Posted
writes are disabled. When the batteries are
fully recharged, the array accelerator will
automatically be re-enabled and this POST
message will go away. Replace the array
accelerator or array controller if batteries do
not recharge within 36 hours after powering
up.
If the battery pack has failed, replace the
battery pack.
1795 Slot x drive array – array accelerator
configuration error. Data does not
correspond to this drive array. Array
accelerator is temporarily disabled. The data stored on the array accelerator
does not correspond to this drive array.
Match the array accelerator to the correct
drive array.
-or-
Run the System Configuration Utility to
clear data on the array accelerator.
1796 Slot x drive array – array accelerator is
not responding. Array accelerator is
temporarily disabled. Replace the array accelerator or the Smart
Array controller.
1797 Slot x drive array – array accelerator
read error occurred. Data in array
accelerator has been lost. Array
accelerator is disabled. Replace the array accelerator or the Smart
Array controller. Restore data from backup.
continued