HONDA 08E02-SHJ-100B - Manual (Page 8)

8 of 12
AII 38137-38714 (0801) © 2008 American Honda Motor Co., Inc. - All Rights Reserved.
7517131E
7517141E
35. Attach template B with masking tape on the roof
console at the indicated position.
34. Drill 4.5 mm holes at the two locations marked on
the roof console in step 32. After drilling, remove
any burrs.
7517120E
DRILL BIT
(4.5 mm)
2 MARKS
ROOF
CONSOLE
PUSHPIN
PUSHPIN
FELT-TIP
PEN
MASKING
TAPE
TEMPLATE B
ROOF
CONSOLE
4 MARKS
39. Drill a 3 mm hole at the four locations marked on
the roof console in step 36.
DRILL BIT
(3 mm)
DRILL BIT
(3 mm 6 mm
10 mm)
19 mm
HOLE SAW
4 MARKS
ROOF
CONSOLE
DRILL
40. Enlarge the two 3 mm holes drilled in step 39 with
a 6 mm drill bit and with a 10 mm drill bit as
shown.
41. Enlarge the other two 3 mm holes drilled in step
39 with a 19 mm hole saw as shown.
36. Use a pushpin to mark the roof console at four
locations according to template B.
37. Use a felt-tip pen and mark the roof console along
the template B.
38. Remove template B.
CENTER OF THE
ROOF CONSOLE
www.collegehillshonda.com