HONDA 08E02-SHJ-100B - Manual (Page 9)

© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38137-38714 (0801)
9 of 12
7517152E
7517171E
7517161E
43. Remove the masking tape attached in step 29.
44. Using isopropyl alcohol on a shop towel, clean the
areas where the double-faced tape will attach.
Remove the adhesive backing from double-faced
tape and attach the double-faced tape at the
indicated position on the control unit.
45. Connect the HFL harness 22-pin connector to the
control unit.
7517180E
2 DOUBLE-FACED
TAPES
CONTROL
UNIT
10 mm 10 mm
CONTROL
UNIT
CENTER
CONTROL
UNIT
CONTROL
UNIT
ROOF
CONSOLE
Remove the
adhesive
backing.
ROOF
CONSOLE
HFL HARNESS
22-PIN
CONNECTOR
HFL
HARNESS
HFL
BRACKET
2 WASHER
SCREWS,
4 x 12 mm
ROOF
CONSOLE
Holes drilled
in step 34.
46. Using isopropyl alcohol on a shop towel, clean the
areas where the double-faced tape will attach.
Remove the adhesive backing from the double-
faced tape attached to the control unit and attach
to the roof console at the indicated position.
47. Use the holes drilled in step 34 and secure the
HFL bracket with two 4 x 12 mm washer screws to
the roof console.
ROOF
CONSOLE
Cut out.
Mark made in
step 37.
42. Using a utility knife, cut along the marking made
on the roof console in step 37. After cutting,
remove any burrs.
ROOF
CONSOLE
Cut out.
UTILITY
KNIFE
www.collegehillshonda.com