Humax PVR-9200T - Manual (Page 19)

**
This will guide you through the installation procedure to automatically search for the Digital channels. (Installation
Wizard will also run after the product has been returned to Default Settings.)
3.1 Search
Please wait until the channel search is complete.
1. During the channel search, the cursor is located at Stop. Therefore, if you press the OK button during the
search, the search will stop and the channels found until then will be displayed.
2. If the search does not find any channels, then press the OK button to access the installation menu to search
for the channels again. Please make sure that you have connected your aerial correctly.
3. You can delete unwanted channels from the found channels. Select your desired channels to delete and press
the OK button. Then select Delete and press the OK button. To delete all channels, select Select All
select all channels, select Delete and press the OK button.
4. After completing the Channel Search and deleting unwanted channels, select Save to save the changes.
**
Warning: If you exit the Install Wizard without fully completing the channel searching procedure, you may not have all
of the channels available. In this case, you can use the Installation Menu to search for the channels.
3. Installation Wizard
GB 18