Honeywell GNS-XL - Manual (Page 293)

SYSTEM OPERATION
PRE-DEPARTURE
AFIS FLIGHT PLAN SELECTION
The AFIS FLIGHT PLAN LIST Page appears after the Initialization
Page. The page also appears between the Active Flight Plan Page
and the first GNS-XL FLIGHT PLAN LIST Page.
NOTE: For aircraft equipped with the Antenna Switching Unit,
DEPRESS momentary AFIS annunciator to enable the air to ground
data link.
TO ENTER AN AFIS FLIGHT
PLAN
1. Preprogrammed AFIS Disk
- INSERT disk into DTU.
2. Select AFIS FLIGHT PLAN
LIST Page using either (a)
or (b).
a. Initialization Page -
Enter Date, GMT, and Initial
Position. AFIS FLIGHT
PLAN LIST Page appears.
b. FPL Key - DEPRESS until desired AFIS FLIGHT PLAN
LIST Page appears. (Figure 7-39)
NOTE: Desired flight plan may be found on a subsequent page if
more than six flight plans have been either transferred from the disk or
received via the data link. If there is more than one Flight Plan with the
same Departure/ Destination pair
a random letter will be displayed
between the Depart?Dest pair
and the date. This letter and the
date distinguish one FPL from
the other.
3. Line Select Key -
DEPRESS to place cursor
over desired Flight Plan.
(Figure 7-40)
7-27 GNS-X L Flight Management System AFIS Operation
Rev. 0
Oct/96
FLIGHT PLAN LIST 1/4
CYUL-KJFK 06APR9O
KJFK-KORD 06APR90
KORD-KSNA 06APR90
KSNA-KSTL 09APR90
GUIII
AFIS
<
<
<
Figure 7-39
AFIS
FLIGHT PLAN LIST 1/4
CYUL-KJFK 06APR9O
KJFK-KORD 06APR90
KORD-KSNA 06APR90
KSNA-KSTL 09APR90
REPLACE ACTIVE FPL?
<
<
<
Figure 7-40