Honeywell GNS-XL - Manual (Page 82)

• START CALC? ENT: This
is displayed when the aircraft
is on the ground and all data
has been entered. Pressing
ENT will start the FDE calcu-
lation and display PLAN 7/8
FDE COMPUTATION. See
Figure 2-59
• NEED ACTIVE FPL: This
will be displayed if there are
less than two waypoints on
the active flight plan.
• BACK FOR NEXT WPT: Displayed when the cursor is over the
start or end waypoint field.
• PRED IN PROGRESS: This is displayed when an FDE prediction is
in progress. All other fields are disabled at this point.
• PREDICTION UNAVAIL: This will be displayed if the GPS is not in
the idle state or the aircraft is not on the ground.
FDE EXCLUDE SATS 1/1 (Page 1 of 1)
This page is accessed by
placing the cursor over the
EXCLUDE SATS (QTY x)
field on PLAN 7/8 Page and
pressing ENT.
EXCLUDE SATS LIST:
The designated satellite num-
ber being excluded from the
FDE prediction is listed here.
SAT #:
The desired satellite being excluded from FDE prediction is entered by
pressing the Line Select Key by this field and entering the number of
the satellite. Press ENT to add the satellite to the list. Entering a
number already listed and pressing ENT will remove the number from
the list. Pressing the Line Select Key next to CLEAR ALL and press-
ing ENT will remove all satellites from the exclusion list.
Page Display Definitions
2-51 GNS-X L Flight Management System
Rev. 0
Oct/96
EXCLUDED SATS LIST
SAT #--
OK? ENTER
FDE EXCLUDE SATS 1/1
<
<
Figure 2-59
EXCLUDED SATS LIST
12 14 02 16 19 22 07
SAT #02
CLEAR ALL
OK? ENTER
FDE EXCLUDE SATS 1/1
<
<
Figure 2-60