Hobart Welding Products IRONMAN M-10 - Manual (Page 16)

OM-927 Page 12
3-6. Connecting To Weld Output Terminals
803 778-A
Y Turn off power before connecting to
weld output terminals.
Y Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your
machine.
1 Weld Output Terminal
2 Supplied Weld Output Terminal Nut
3 Weld Cable Terminal
4 Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar. Do not place anything between weld
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
Tools Needed:
3/4 in (19 mm)
4
2
3
Do not place
anything between
Correct Installation Incorrect Installation
1
weld cable terminal
and copper bar.
3-7. Installing Work Clamp Cable
1 Work Cable
Route cable through opening in
front panel.
2
Negative (−/Black) Output
Terminal
Connect cable to terminal.
Close door.
Ref. 802 601-A / Ref. 801 566-B
Tools Needed:
3/4 in
2
1