Husqvarna 18 ProFlex - Manual (Page 19)

English –
17
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
Check the engine’s oil level 19 ●
Check the engine’s cooling air inlet 19 ●
Check the fuel pump’s air filter 19 ●
Check the transmission’s air inlet 20 ●
Check the transmission’s oil level 20 ●
Check the steering wires 21 ●
Check the battery 22 ●
Check the safety system 22 ●
Check screws and nuts – ❍
Check for fuel and oil leakage – ❍
Clean the air filter’s pre-filter (foam plastic) 2) 23 ●
Check the cutting unit 27 ●
Check the tyre pressures (60 kPa) 36 ●
Adjust the brakes 22 ●
Check the V-belts – ❍
Change the engine oil 1) 33 ●
Lubricate joints and shafts 3) 34 ●
Check and adjust the throttle wire 35 ●
Replace the air filter’s pre-filter and paper filter 2) 23 ●
Replace the oil filter 34 ●
Replace the fuel filter 36 ●
Clean the pulse-air filter 38 ●
Replace the plugs – ❍
Clean the engine’s and the hydrostat’s cooling flanges 2,4) – ❍
Check the valve clearance 4) – ❍
Check the valves and seats 4) – ❍
1) First change after 8 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the
machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.
25 50 100 300
MAINTENANCE
!
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed from the plugs.
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance
● = Described in these instructions.
❍ = Not described in these instructions.
Daily
main-
tenance
before start
Page
Maintenance interval
in hours