HP UX B6941-90001 - Manual (Page 113)

Chapter 2 113
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
NOTE If the password line is left in its default state (empty) a random
password is generated. If you want to use a specific password, it needs to
be encrypted on the ITO management server with the
opcpwcrpt tool,
which resides in /opt/OV/bin/OpC/install .
If you are installing the ITO agent software on a domain controller, do
not let ITO create a password for you, but specify your own. You will
need this password again when installing on another domain controller.
3. Create the following file in the C:\temp directory of the NT managed
node:
• File: nodeinfo
OPC_NODE_TYPE CONTROLLED
OPC_MGMTSV_CHARSET iso88591
(or sjis for Japanese)
OPC_NODE_CHARSET acp1252 (or acp932 for Japanese)
OPC_COMM_TYPE RPC_DCE_TCP
OPC_NSP_TYPE [NONE | SECRET]
1
(for ANS only)
OPC_NSP_VERSION 0 (for ANS only)
1. One or the other depending on your ANS setting requirements
NOTE If the ITO agent version A.04.x or lower is already installed on the
managed node, run the following commands to stop the ITO agent on the
node and remove the old
nodeinfo file, which is incompatible with ITO
A.05.00 agent, before you continue with the re-installation:
a. \usr\OV\bin\OpC\[intel | alpha]\opcagt -kill
b. del \usr\OV\conf\OpC\<node>\nodeinfo
4. Run the setup batch file on the NT PC from a command prompt:
C:
cd \temp
opc_pre.bat
5. On the management server, add the NT node to the appropriate node
group.
6. When the NT PC is connected to the ITO management server, update
the database and start heartbeat polling for the NT node manually,
from the management server, as follows: