Husqvarna HUV4210-GXP - Manual (Page 17)

Controls and Indicators
1
2
41
Figure 7 Key Switch – Gasoline Vehicle
Electric Vehicles
The key switch is mounted on the dash to the right of the steering column. It has two positions, OFF and ON, which
are clearly labeled. See following NOTE.
NOTE: The key can be removed only when the key switch is in the OFF position.
FORWARD/REVERSE CONTROL
Gasoline Vehicles
The Forward/Reverse handle is located on the seat support panel (Figure 8). The handle has three distinct positions:
F (FORWARD), N (NEUTRAL), and R (REVERSE). Rotate the handle towards the driver (FORWARD) to operate the
vehicle in the forward direction, or towards the passenger (REVERSE) to operate the vehicle in reverse. Husqvarna
vehicles operate at reduced speed in REVERSE. The engine can be started only when the handle is in the straight
up position (NEUTRAL). The engine must be at idle before shifting the Forward/Reverse handle. See preceding
WARNING and CAUTION.
Electric Vehicles
The Forward/Reverse rocker switch is located on the seat support panel (Figure 9). The F (FORWARD) and R
(REVERSE) positions are clearly marked. Push down the FORWARD side of the switch to operate the vehicle in the
forward direction, or push down the REVERSE side of the switch to operate the vehicle in reverse. When the rocker
switch is positioned in the NEUTRAL position, with neither side down, the vehicle will not operate if the accelerator
pedal is pressed. The reverse buzzer will sound as a warning when the Forward/Reverse switch is in the REVERSE
position. Husqvarna vehicles operate at reduced speed in REVERSE.
2009 HUV4210 Owner’s Manual Page 15