Husqvarna HUV4210-GXP - Manual (Page 42)

Battery Charger – Electric Vehicles
18A
Figure 21 Correct Insertion of Charger DC Plug
43
Figure 22 Incorrect Insertion of Charger DC Plug
Husqvarna electric vehicles are supplied with a PowerDrive battery charger (Husqvarna 603 00 20-09). Use only
PowerDrive chargers with this electric vehicle.
As long as the charger is allowed to shut off by itself, the batteries will be fully charged. Overcharging and
undercharging will normally be prevented.
Batteries should be put on charge even if they have been used for only a short period (10 minutes). The charger is
automatic and will turn off when batteries are fully charged. If the charger does not seem to be operating properly, or if
the batteries seem weak, contact your local Husqvarna distributor/dealer.
PLUG AND RECEPTACLE
The charger cord, plug, and receptacle are wear items and should be inspected daily. Visually inspect them for cracks,
loose connections, and frayed wiring; they must be replaced when worn or damaged. If charger plug or receptacle
show signs of corrosion or the plug is difficult to insert or remove, the receptacle contacts and plug terminals should
be cleaned with a good electrical contact cleaner or lightly sprayed with WD-40
® brand spray lubricant. The plug
should then be inserted and removed several times to ensure ease of insertion, ease of removal, and good electrical
contact. See following NOTE.
NOTE: If the warning tag has been damaged or removed from the DC cord, have it replaced immediately.
Page 40 2009 HUV4210 Owner’s Manual