Husqvarna HUV4210-GXP - Manual (Page 30)

Storage – Gasoline Vehicles
allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry and then coat them with
Battery Terminal Protector Spray (Husqvarna 603 00 00-03).
3. Store vehicle in a cool, dry place. This will minimize battery self-discharge.
4. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 48.
5. Perform semiannual periodic lubrication. See Periodic Lubrication Schedules on page 34.
6. Thoroughly clean front body, rear body, seats, battery compartment, and underside of vehicle.
7. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
8. Keep batteries fully charged during storage.
– Leave chargers plugged in during storage. The onboard computer will automatically activate the charger when
necessary. If charger cannot remain plugged in, or AC power will not be available during extended storage,
disconnect the batteries for storage (Figure 3). See following CAUTION.
CAUTION
• Be sure to check the batteries and charger monthly to maintain correct battery water level and to
ensure the charger is operating correctly during storage.
RETURNING THE STORED ELECTRIC VEHICLE TO SERVICE
1. If necessary, connect batteries and tighten terminals to 110 in-lb (12.4 N·m).
2. Fully charge batteries.
3. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 48.
4. Perform the Pre-Operation and Daily Safety Checklist on page 20.
STORAGE – GASOLINE VEHICLES
See General Warnings on page 10.
DANGER
• Do not attempt to drain fuel when the engine is hot or while it is running.
• Be sure to clean up any spilled gasoline before operating the vehicle.
• Store fuel in an approved fuel container only. Store in a well-ventilated area away from sparks, open
flames, heaters, or heat sources.
• Keep fuel out of the reach of children.
• Do not siphon fuel from the vehicle.
WARNING
• Only trained technicians should service or repair the vehicle or battery charger. Anyone doing even
simple repairs or service should have knowledge and experience in electrical and mechanical repair.
The appropriate instructions must be used when performing maintenance, service, or accessory
installation.
• Turn the key switch to the OFF position, remove the key, and leave the Forward/Reverse handle in
the NEUTRAL position during storage. This is to prevent unintentionally starting the vehicle or a
fire hazard.
• Turn the fuel shut-off valve to the closed (OFF) position (Figure 17).
Page 28 2009 HUV4210 Owner’s Manual