Husqvarna HUV4210-GXP - Manual (Page 49)

Cleaning the Vehicle
1
3
2
1. Vent 2. Fuel Shut-off Valve 3. Vent Tube
24
Figure 31 Fuel Tank
CLEANING THE VEHICLE
Husqvarna vehicles are equipped with ABS front bodies and TPO for rear bodies. Use only commercially available
automotive cleaners with a sponge or soft cloth for normal cleaning. A garden hose at normal residential water
pressure is adequate.
Husqvarna does not recommend any type of pressure washing or steam cleaning. Such a process (especially if the
vehicle has the rear body removed) will expose electrical components to moisture. Moisture entering electrical
components can result in water damage and subsequent component failure.
Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should be
removed immediately to prevent possible stains.
The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm water applied
with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult stains or scratches,
blemishes, or other body damage, see the appropriate maintenance and service manual.
NOTE: Dispose of waste water properly.
ACCESSORIES
There is a complete line of accessory equipment available from Husqvarna and our dealers/distributors. You can obtain
the name and phone number of your closest Husqvarna contact by visiting our web site at www.usa.husqvarna.com.
Care should be taken that these accessories are properly installed by trained technicians, and that they are used in
the manner for which they were designed.
SUBSEQUENT OWNER REGISTRATION
In the event a vehicle is bought as a used vehicle, we strongly urge the new owner to register the vehicle with
Husqvarna. This will enable us to contact you if the need arises. Please send your name, address, and serial number
of the vehicle to Husqvarna, 7349 Statesville Rd., Charlotte, NC 28269, Attention: Vehicle Registration.
2009 HUV4210 Owner’s Manual Page 47