Husqvarna 125/2002 User Manual

Page 254

Advertising
background image

254

PULIZIA

1) Preparazione per il lavaggio
Prima del lavaggio, prendere le seguenti
precauzioni per impedire che l’acqua entri
a contatto con le seguenti parti:

Apertura posteriore dello scarico:

- Coprire con una busta in plastica

fissandola con fascette in gomma

Leve frizione e freno anteriore,

manopole, pulsante arresto motore:

- Coprire con una busta in plastica

Aspirazione filtro aria:

- Chiudere l’apertura con del nastro o dei

panni puliti

2) Dove porre particolare attenzione
- Non spruzzare acqua a pressione

elevata vicino alle seguenti parti:

Filtro aria

Sotto il serbatoio carburante

Se l’acqua entra nella bobina o nella

pipetta candela, il motore non partirà e
sarà necessario asciugare tutte le parti
bagnate

Testa di sterzo forcella, cuscinetti ruote.

CLEANING

1) Preparation for washing
Before washing, precautions must be taken
to keep water out of the following places:

Rear opening of the muffler :

- Cover with a plastic bag

secured with rubber bands.

Clutch and brake levers, hand grips,

engine stop button:

- Cover with plastic bags.

Air cleaner intake:

- Close up the opening with tape, or stuff

in rags.

2) Where to be careful

Avoid spraying water with any great force
near the following places:

Air cleaner

Under the fuel tank:

If water gets into the ignition coil or into
the spark plug cap, the spark will jump
through the water and be grounded
out. When this happens,the motorcycle
will not start and the affected parts must
be wiped dry.

Fork head, wheel bearings.

NETTOYAGE

1) Préparation pour le lavage
Veillez à ce que de l’eau n’entre pas en
contact des éléments suivants:

Ouverture arrière d’échappement:

- Couvrir par une enveloppe en plastique

en la fixant avec des colliers en
caoutchouc

Leviers d’embrayage et du frein arrière:

- Couvrir par une enveloppe en

poignées, boutons d’arrêt moteur

plastique

Suction filtre à air:

- Fermer l’ouverture avec du ruban, ou des

chiffons propres

2) Veillez à ce que:

De l’eau à fort pression ne soit pas
vaporisée sur les éléments suivants:

Filtre à air

Au dessous du réservoir carburant. Si de

l’eau entre dans la bobine ou dans
la pipette de la bougie, le moteur ne
démarre pas. Essuyer les éléments
mouillés.

Tête de direction, fourche, paliers des

roues.

IMP.13-125-2002 11-12-2001 9:10 Pagina 254

Advertising