HP 2500CMHP - Manual (Page 28)

11
10
9
8
7. Push in the PostScript 3 Module until the two clips snap into place.
8. Lift the plastic flap, place the metal panel on the Rear Access Door
and fasten the screws.
9. Reconnect all cables to the back of the printer and power ON the
printer.
10. To verify installation of the PostScript 3 Module, select the PostScript
Firmware Version option in the Information Menu from the key panel.
11. The installed PostScript Firmware Version is displayed on
the LCD panel.
24
7
PS FW VER
X.X.X