7. overload protection (subaru-powered units) – Hobart Welding Products CHAMPION ELITE OM-240 438B User Manual
Page 41
.
A complete Parts List is available at www.HobartWelders.com
OM-240 438 Page 37
8-7. Overload Protection (Subaru-Powered Units)
244 029-A
!
Stop engine. Disconnect
negative (−) battery cable.
1
F1 protects the weld excitation
winding from overload. If F1 opens,
weld output stops or is low.
2
F2 protects the generator power
excitation winding from overload. If
F2 opens, generator power output
stops or is low.
3
F6 protects the engine wiring sys-
tem from overload. If F6 opens,
engine will not crank.
Replace any open fuses. Reinstall
cover before operating.
NOTICE − If a fuse opens, it usually
indicates a more serious problem
exists. Contact a Factory Autho-
rized Service Agent.
3/8 in.
Tools Needed:
2
1
.
Fuses F1, F2 located on
bracket behind left side
panel.
3
.
Fuse F6 located in
harness behind left
side door.