Husqvarna 15V2s AWD - Manual (Page 14)

14 – English
PRESENTATION
Cutting unit
Rider 15V2, Rider 15V2s AWD and 15V2 AWD can be
equipped with two different cutting units.
• Combi 1030mm/41”
• Combi 1120 mm/44”
The Combi-unit, equipped with a BioClip-plug, finely chops
the cuttings to fertiliser. Without the BioClip-plug the unit
works in the same way as a rear ejection unit.
Lifting lever for the cutting unit
The lift lever is used to set the cutting unit in transport or
mowing position.
If the lever is pulled backwards the unit is raised and the
blades automatically stop rotating (transport position).
If the lock button is pressed in and the lever is moved forwards
the unit will be lowered and the blades will automatically start
to rotate (mowing position).
The lever can also be used to temporarily regulate the cutting
height, e.g. for a small mound in the lawn.
Cutting height adjustment lever
The cutting height can be adjusted to 7 different positions with
the cutting height lever.
Combi-unit 40-90 mm (1 9/16” - 3 9/16”)
Lights
The lights are switched on and off using the power switch on
the control panel.
Counter
The chronometer shows how many hours the engine has
been running. Any time when the engine is not running but the
ignition is switched on is not registered. The last digit shows
tenths of an hour (6 minutes).
Seat
The seat has a jointed attachment on the front edge and can
be tipped forward.