Husqvarna 15V2s AWD - Manual (Page 26)

26 – English
Maintenance
Checking the engine’s cooling air
intake
Clean the air intake grille in the engine cover behind the
driver’s seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
Check the air duct, located on the inside of the engine cover,
ensure it is clean and does not rub against the cooling air
intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
Fitting the cutting head
1 Place the Rider on a flat surface and apply the parking
brake.
2 Check that the lever for setting the cutting height is in the
lowest position and that the lifting lever for the cutting unit
is in mowing position.
Make sure the support wheels (1) are fitted to the cutting
unit.
3 Grasp the handle at the front or hold the frame of the
cutting unit (2) and slide the unit underneath the rider
mower.
4 Check that the pin is fitted correctly.
5 Insert the bolt and secure it with a locking pin.
6 Press down the frame and remove the pin.
!
WARNING! The cooling air intake rotates
when the engine is running. Mind your
fingers.
!
WARNING! Wear protective glasses when
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
1
2
3
!
WARNING! Observe caution to avoid
trapping your hand.