Placing in the service position, Maintenance – Husqvarna 15V2s AWD User Manual
Page 29
English
– 29
Maintenance
Placing in the service position
1
Position the machine on flat ground. Apply the parking
brake. Adjust the cutting unit to the lowest cutting height
and lower the cutting unit.
2
Remove the front hood by removing the pin. (There are
complete instructions on using the service position inside
the front hood).
3
Remove the two support wheels from under the front
hood.
4
Fit the support wheels on either side of the rear of the
cutting unit.
5
Disengage the spring for the drive belt tensioning wheel.
Rider 15V2
Rider 15V2 AWD
6
Place a foot on the front edge of the cutting unit near the
wheel and raise the front edge of the unit to make it easier
to remove the lift strut.
7
Engage the strut in the holder.
!
WARNING! Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.