Husqvarna 15V2s AWD - Manual (Page 3)

English – 3
Ser vice journal
Pre-deliver y service
1 1a. Dry-charged battery (506788801) Fill the battery with battery acid and charge for 4 hours at max. 6 amp.
1b. Wet-charged battery (510138501) Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional equipment.
3 Check and adjust tyre pressure (60 Kpa, 0.6 bar, 9 PSI).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4 mm / 1/8” higher than front edge.
Adjust cutting unit height setting so that cutting height limit is 5 mm / 3/16” above the frame of the unit at the lowest
cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission’s oil tank.
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
The safety switch for the hydrostat pedals.
11 Check the engine speed See the Technical data section.
12 Check the synchronisation between the front and rear wheels. (Only AWD-machines) See the workshop manual.
13 Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the second-hand value of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems. Certified:
______________________________________________________
Date , mileage, stamp, signature
After the fi rst 8 hours
1 Change engine oil
2 Change the oil in the gearbox.