Document Outline

• IMB-T10
• Revision History
• Preface
  • Audience and Scope
  • Manual Organization
• Table of Contents
• List of Figures
• List of Tables
• 1 Introduction
  • 1.1 Package Contents
  • 1.2 Overview
  • 1.3 Features
  • 1.4 Specifications
  • 1.5 Block Diagram
  • 1.6 Functional Description
    • Processor Support
    • Intel® NM10 Express Chipset
    • DDR3 memory
    • Intel® Graphics Media Accelerator GMA 3650
    • Gigabit Ethernet
    • Serial ATA
    • USB 2.0
    • Hardware Monitoring
    • Watchdog Timer
  • 1.7 Mechanical Dimensions
• 2 Hardware Information
  • 2.1 Rear I/O Layout
  • 2.2 Rear I/O Connector Pin Definitions
    • VGA Connector.
    • USB Connectors
    • LAN Port (RJ-45)
    • COM1/2 Connectors (DB-9)
    • COM1 RS-232/422/485 Mode Select (J3)
    • HDMI Connector
    • Audio Ports
  • 2.3 Board Layout
  • 2.4 Onboard Connector Pin Definitions
    • LVDS Panel Connector (LVDS1/2)
    • SATA Signal Connectors (SATA2_1/2)
    • SATA Power Output Connectors (SATA_PWR1/2)
    • COM3~6 Connector (COM3_6)
    • COM7~10 Connector (COM7_10)
    • CPU/Chassis Fan Connectors (CPU/CHA__FAN1)
    • System Panel Header (PANEL1)
    • Front Panel Audio Header (HD_AUDIO1)
    • USB 2.0 Headers (USB4_5, USB6_7)
    • Chassis Intrusion Headers
    • TPM Header (TPM1)
    • Keyboard/Mouse Connector (KB_MS1)
    • ATX 12V Power Connector (ATX12V1)
    • LAN Active LED Headers (LAN LED1/2)
    • Inverter Connectors (Inverter1/2)
    • Backlight Volume Control (BLT_VOL1)
    • Digital IO Header (DGIO1)
  • 2.5 Jumper Settings
    • Clear CMOS Header
    • Backlight PWM
    • Panel Power
    • mSATA Mode
    • ATX/AT Mode Selection
    • COM Power
• 3 Getting Started
  • 3.1 Screw Holes
  • 3.2 Pre-installation Precautions
  • 3.3 Installation of Memory Modules (SO-DIMM)
  • 3.4 Expansion Slots (PCI, PCI Express and Mini-PCIe/mSATA)
    • Installing an expansion card
  • 3.5 Driver Installation
• 4 BIOS Setup
  • 4.1 Introduction
    • 4.1.1 UEFI Menu Bar
    • 4.1.2 Navigation Keys
  • 4.2 Main Screen
  • 4.3 Advanced Screen
    • Instant Flash
      • 4.3.1 CPU Configuration
    • Intel Hyper-Threading Technology
    • No-Execute Memory Protection
      • 4.3.2 CPU Configuration
    • LVDS1 Panel Type Selection
    • LVDS2 Panel Type Selection
    • Primary Graphics Adapter
    • ACPI HPET Table
    • Restore on AC/Power Loss
    • Onboard HD Audio
    • Front Panel
    • Onboard LAN1
    • Onboard LAN2
      • 4.3.3 Storage Configuration
    • SATA Mode
    • Hard Disk S.M.A.R.T.
      • 4.3.4 Super IO Configuration
    • COM1~10 Configuration
    • WDT Timeout Reset
      • 4.3.5 ACPI Configuration
    • Suspend to RAM
    • S3 Video Repost
    • Check Ready Bit
    • PS/2 Keyboard Power On
    • PCI Devices Power On
    • RTC Alarm Power On
    • USB Keyboard/Remote Power On
    • USB Mouse Power On
      • 4.3.6 USB Configuration
    • USB 2.0 Controller
    • Legacy USB Support
  • 4.4 Hardware Health Event Monitoring System
    • CPU_FAN1 Setting
    • CHA_FAN1 Setting
    • Case Open Feature
    • Clear Status
  • 4.5 Boot Screen
    • Setup Prompt Timeout
    • Bootup Num-Lock
    • Full Screen Logo
    • Boot From Onboard LAN
  • 4.6 Security Screen
  • 4.7 Exit Screen
    • Save Changes and Exit
    • Discard Changes and Exit
    • Discard Changes
    • Load UEFI Defaults
    • Launch EFI Shell from file system device
• Appendix A - WDT Sample Code
• Important Safety Instructions
• Getting Service