ADLINK IMB-T10 - Manual (Page 39)

Getting Started 27
IMB-T10
3 Getting Started
The IMB-T10 is a Mini-ITX form factor (6.7" x 6.7", 17.0 x 17.0 cm)
motherboard. Before you install the motherboard, check the con-
figuration of your chassis to ensure that the motherboard fits into
it.
3.1 Screw Holes
Place screws into the holes and tighten to secure the motherboard
to the chassis.
3.2 Pre-installation Precautions
Take note of the following precautions before you install mother-
board components or change any motherboard settings.
1. Unplug the power cord from the wall socket before
touching any component.
2. To avoid damaging the motherboard components due to
static electricity, always use a grounded wrist strap.
3. Hold components by the edges and do not touch the ICs.
4. Whenever you uninstall any component, place it on a
grounded antistatic pad or in the bag that comes with the
component.
WARNING:
Make sure to unplug the power cord before installing or remov-
ing the motherboard. Failure to do so may cause physical inju-
ries to you and damage to motherboard components.
CAUTION:
Do not over-tighten the screws! Doing so may damage the
motherboard.
WARNING:
Before you install or remove any component, ensure that the
power is switched off or the power cord is detached from the
power supply. Failure to do so may cause severe damage to
the motherboard, peripherals, and/or components.