Document Outline

• FOREWORD
• SAFETY ALERT SYMBOLS AND SAFETY SIGNAL WORDS
• REVISION LOG
• Section 1. SAFETY PRECAUTIONS
• 1.1 General
• 1.2 Pre-operation
  • Operator Training and Knowledge
  • Workplace Inspection
  • Machine Inspection
• 1.3 Operation
  • General
  • Trip and Fall Hazards
  • Electrocution Hazards
  • Tipping Hazards
  • Crushing and Collision Hazards
• 1.4 Towing, Lifting, and Hauling
• 1.5 Additional Hazards / Safety
• Section 2. Preparation and Inspection
  • 2.1 General
  • 2.2 Preparation for Use
  • 2.3 Delivery and Periodic Inspection
    • Handrail Assemblies
    • Platform Assembly
    • Sizzor Arms
    • Electrical Cable
    • Pivot Pins
    • Lift Cylinder
    • Frame
    • Tire and Wheel Assemblies
    • Sliding Wear Pad Blocks
    • Hydraulic Oil Supply
    • Steer Cylinder
    • Steer Linkage
    • Front Spindle Assemblies
    • Control Boxes (Console and Ground)
    • Battery
    • Engine
    • Hydraulic Pump and Valves
    • Platform Placards
  • 2.4 Daily Walk-Around Inspection
    • Overall Cleanliness
    • Placards
    • Operators, Service, and Parts Manual
    • Machine Log
    • Daily Lubrication
  • 2.5 Daily Functional Check
  • 2.6 Torque Requirements
  • 2.7 Dual Fuel System
• Section 3. user responsibilities and machine control
  • 3.1 General
  • 3.2 Personnel Training
    • Operator Training
    • Training Supervision
    • Operator Responsibility
  • 3.3 Operating Characteristics and Limitations
    • General
    • Placards
    • Capacities
    • Stability
  • 3.4 Controls and Indicators
    • Ground Control Station
  • 3.5 Platform Control Station
• Section 4. machine operation
  • 4.1 Description
  • 4.2 General
  • 4.3 Engine Operation
    • Platform/Ground Select Switch
    • Emergency Stop Switch
    • Starting Procedure
  • 4.4 Raising and Lowering
    • Raising
    • Lowering
    • Platform Extension
  • 4.5 Steering
  • 4.6 Traveling
    • Traveling Forward
    • Traveling in Reverse
  • 4.7 Parking and Stowing
  • 4.8 Platform Loading
  • 4.9 Safety Prop
  • 4.10 Tie Down/Lift Lugs
    • Lifting
  • 4.11 Towing
• Section 5. Emergency Procedures
  • 5.1 General
  • 5.2 Emergency Towing Procedures
  • 5.3 Emergency Controls and Their Locations
  • Emergency Stop Switch
  • Ground Control Station
  • Manual Descent
    • 5.4 Emergency Operation
  • Operator Unable to Control Machine
  • Platform Caught Overhead
  • Righting of Tipped Machine
  • Post-Incident Inspection
    • 5.5 Incident Notification
    • Table 6-1. Inspection and Repair Log
• Corporate Office
• JLG Industries, Inc.
• 1 JLG Drive
• McConnellsburg PA. 17233-9533
• USA
• Phone: (717) 485-5161
• Fax: (717) 485-6417