Document Outline

• 150-UM009D-EN-PTOC.pdf
  • Table of Contents
• intro.pdf
  • Chapter 1
    • Introduction
      • Component Overview
        • Figure 1 - Bulletin 150-E Components
        • Base Controller
        • Fault Contactor
      • Function Overview
        • Motor Control
        • Diagnostics
      • Starter Selection
        • For 6 or 12 Lead Wye-Delta Wound Motors
          • Table 1 - Cat. Nos. For Use with 6- or 12-Lead Wye-Delta Motors
        • For 3- or 9-Lead Closed Delta-Type Motors
          • Table 2 - Cat. Nos. For Use with 6 or 12 Lead Closed Delta-Type Motors
• instal.pdf
  • Chapter 2
    • Installation & Wiring
      • Unpacking
      • Mounting
      • Dimensions
        • Figure 2 - Panel Dimensions for 32, 51, & 64 A Elevator Panels
        • Figure 3 - Panel Dimensions for 74, 104, & 147 A Elevator Panels
        • Figure 4 - Panel Dimensions for 234 A Elevator Panels
      • Installation Precautions
        • Motor Branch Protection and Disconnecting Means
        • Electrical Noise Suppression
        • Power Factor Correction Capacitors (PFCC).
      • Terminal Torque Specifications
        • Table 3 - Controller Information
        • Table 4 - Fault Contactor Information
      • Delta Connection
        • Figure 5 - Diagram, Power, & Motor Wiring
      • Delta Connection (continued)
      • Line Connection
        • Figure 6 - Diagram, Power, & Motor Wiring
      • Line Connection (continued)
      • Delta-Connected Controller
        • Figure 7 - Typical Control Wiring
      • Line-Connected Controller
        • Figure 8 - Typical Control Wiring
• program.pdf
  • Chapter 3
    • Programming
      • DIP Switch Settings
        • Table 5 - Start Time
        • Table 6 - Start Mode
        • Table 7 - Current Limit/Initial Torque Level
        • Table 8 - Soft Stop Time
        • Table 9 - Phase Rotation
        • Table 10 - Phase Imbalance
        • Table 11 - Overload Trip Class
        • Table 12 - Overload Reset
        • Table 13 - Aux #1 Setting
        • Table 14 - Motor Connection Type
        • Table 15 - Stop Delay
      • Motor FLA Requirements
        • Figure 9 - FLA Setting of Motor
        • Motor Overload Trip Curves
          • Figure 10 - Trip Class
        • Input & Output Timing
          • Figure 11 - Input & Output Timing
• troubleshoot.pdf
  • Chapter 4
    • Troubleshooting
      • Introduction
      • Diagnostics Indication
        • Table 16 - LED Fault Indication & Diagnostics
      • Troubleshooting Steps
        • Table 17 - Troubleshooting Steps
      • Repair Parts
        • Table 18 - Repair Parts
• specs.pdf
  • Chapter 5
    • Specifications
      • Electrical
        • Table 19 - Power Circuit
        • Table 20 - Control Circuit
        • Table 21 - Short Circuit Capabilities
        • Table 22 - Auxillary Contacts (Fault & Aux #1)
        • Mechanical
          • Table 23 - Mechanical
        • Environmental
          • Table 24 - Environmental
      • Dimensions & Shipping Weights
        • Figure 12 - Dimensions
        • Table 25 - Dimensions & Shipping Weights