Heatiator Heatilator Evolution NEVO4236I NEVO3630I - Manual (Page 38)

Heatilator • Evolution • 4065-114 Rev. o • 11/11 38
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during installa-
tion. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
A. Top Vent
9 9
Appliance Preparation
Figure 9.1
Figure 9.2
Figure 9.3
Figure 9.4
Figure 9.5
• Discard the vent cap, remove and discard the insulation
basket.
Note: Once the vent cap has been removed it cannot
be reattached.
• Fold the center parts of the retaining band up and use
to remove the vent cap.
• Remove the cover plate by removing the four screws
holding it to the top of the appliance. Remove and discard
the cover plate.
• Remove the center insulation plug.
• Cut the metal retaining band and fold the sides out.
• Snap the fi rst vent section into place.