Harman PP38+ - Manual (Page 22)

22 PP38+ Pellet Stove 3-90-08422R33_06/13
burn Pot cleaning and Maintenance
1. Scrape the top holed surface and sides of the burn pot.
(Fig 33) It is not necessary to completely remove all
material from the burn pot. The excess will be pushed out
during the next use.
2. Loosen the (2) wing thumb screws on the lower front angle
of the burn pot. (Fig. 34)
3. Lift off the clean-out cover (Fig.35) to open the bottom
clean-out chamber. (Fig.36)
4. Clean ash buildup from inside the chamber while cover
is off. Use the scraper to tap on the top front edge of the
burn pot. This will help knock pieces of ash, loosened by
the scraping process, down through the holes.
5. Be sure the cover is in place on the screws and hand-
tighten the wing screws.
DANGER
Disconnect the power to the unit before removing
cover.
Maintenance - burn Pot
Fig. 34 Loosen wing screws
Fig. 35