Follett 25 - Manual (Page 13)

Installing Satellite-fill icemakers
Models 25CR400A/W, 50CR400A/W, 25HR400A/W, 50HR400A/W
1. Install Satellite-fill icemaker following instructions in icemaker manual.
2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out (Fig. 5G) or through counter
opening to icemaker.
3. Insulate ice transport tube by sliding insulation over tube.
4. Adjust insulation to cover all exposed ice transport tubing including tubing inside dispenser cabinet.
5. Check that insulated ice transport tube runs continuously uphill (with no dips) from icemaker to dispenser.
6. Run bin signal wire from dispenser through utility knockout (Fig. 5F) or counter cut-out to icemaker and connect bin
signal wire (two-conductor twist lock) to bin signal plug on icemaker.
7. Plug dispenser power cord into 20 amp rated NEMA 5-20 wall socket.
8. Turn on dispenser water supply and check for leaks. Replace splash panel.
9. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispenser lenses.
10. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward. Turn
on power and bin signal rocker switches. Replace front cover and secure with screws. Test operation.
11. Clean and sanitize icemaker following instructions in icemaker manual. Discard ice made during sanitizing process.
12. Clean and sanitize dispenser hopper following instructions on page 16. Installation is complete.
13
engaging pin
.187 (5mm) ice tube hole
ice hose mounting bracket
ice level control stat
ice tube
1"
(25mm)
See Icemaker Installation Manual (form #208600) for critical installation instructions for Satellite-
fill icemakers. Failure to comply with these instructions will result in poor performance and void
warranty.
!
Fig. 9 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop units
with Satellite-fill icemaker