Follett 25 - Manual (Page 8)

12 Verify that water sensor tabs are immersed in water in reservoir.
13. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward.
14. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispense sensor labels.
15. Turn on dispenser power and bin signal rocker switches. Check dispenser and icemaker operation.
16. Sanitize icemaker according to instructions in icemaker manual. Discard ice made during sanitizing process.
17. Turn off icemaker bin signal switch.
18. Remove dispenser hopper lid; clean and sanitize dispenser according to instructions beginning on page 16.
19. Turn icemaker bin signal switch on and replace front covers, securing with screws.
8
31.5"
(800mm)
15.125"
(384mm)
3.125"
(79mm)
3.125"
(79mm)
10.25"
(259mm)
10.5"
(267mm)
6.75"
(171mm)
.8"
(20mm)
(B) 3/4" FPT drain
power cord
(C) 3/4" MPT icemaker drain location
(water-cooled only)
(E) 3/8" FPT condenser outlet location
(water-cooled only)
(B) 3/4" MPT icemaker drain location
(air-cooled only)
(D) 3/8" FPT condenser inlet location
(water-cooled only)
access panel
(A) 3/8" FPT
water inlet
Fig. 1 – Rear connections, freestanding models