Furuno FM-8800S - Manual (Page 14)

1. MOUNTING
1-6
Printer (option)
Printer PP-510
To mount the printer, refer to the printer outline drawing at the back of this manual.
1. Select a flat surface.
2. Fix the mounting base to the mounting location with four screws (supplied).
3. Lay the printer on the top of the mounting base and fasten it with the mounting fixtures
(two at each side and one at rear).
Mounting Fixture
Mounting Fixture
Mounting Dimensions 300 (H) x 396 (W) mm
Mounting of Printer PP-510
Printer PP-8800
The printer PP-8800 is flush-mounted in a panel. Refer to the outline drawing at the back of
this manual.
1. Make a cutout of 208(w) x 118(h) mm.
2. Set the printer and fix it with four self-tapping screws (4x16).
Printer Interface (option)
The printer interface IF-8500 is required for the printer PP-510 which is commonly used with
the FM-8800D/S and other MF/HF radio communication equipment. To mount the unit, see
the outline drawing at the back of this manual.
External Loudspeaker (option)
The external loudspeaker can be installed on a tabletop, the overhead or a bulkhead.
Fasten the loudspeaker to the mounting location with self-tapping screws, or nuts, bolts and
washers. For mounting dimensions, see the outline drawing at the back of this manual.