Furuno FM-8800S - Manual (Page 30)

3-2
2. Fix the panel assembly to the Transceiver Unit with binding screws (use original binding
screws of the Transceiver Unit). Refer to the figure below.
3. Screw in hex bolts M8x16 and flat washers loosely at both sides of the Transceiver Unit.
Panel assembly
Binding screw M4 2 places
(Use the original screws
of the Transceiver Unit.)
Hex bolt M8X16
2 places
(faster loosely)
Washer M8
2 places
4. Set the Transceiver Unit to the console, remove the grommets from the console and fix
the Transceiver Unit with hex bolts using the holes formerly occupied by the grommets.
Hex head screws
Mounting
plate
Transceiver
Unit
Connecter
Connecter
Mounting of
the Transceiver Unit
Close the hole with grommets
lastly.
Flat washer
Insert console upside down.
Fix Mounting Plate
between washers.
5. Connect connector from the fuse to the power connector derived from the Transceiver
Unit.