Furuno FM-8800S User Manual

Page 22

Advertising
background image

2. CONNECTIONS

2-4

Connecting the Remote Station without the Junction

Box

The remote station (or DMC Interface, Mic. Receptacle box, etc) can be connected directly

to the transceiver unit, using the D-sub connector supplied as installation materials.

Attach the connector to the cable as follows.

Shield tape (metal)
Fold back the armor,
and then wind the shield
tape along the edge of cable.

Cable clamp

Cable

Connector XM2A-3701 &
Housing case XM2S-3712

Attachment of connector

When the handset HS-2003 is not connected to the

Transceiver unit

When the handset HS-2003 is not connected to the transceiver unit, i.e.,always the remoted

handset is used, the following modification is necessary.

1. Dismount the cover of the transceiver unit by removing four screws at the rear panel and

two screws at the side.

2. Dismount the bottom cover by removing seven screws.

CPU board
05P0773

J15

3. Shorten between #1 and #2 of J15. The handset line of the HANDSET port becomes

always “ON HOOK”.

4. Assemble the unit.

Advertising