FORD Vehicle - Manual (Page 88)

86
dots and HI beside the H control knob. The HI
position provides the most air flow.
* [IP01540(B F )03/95] Air flow selections
* [IP01542(B F )03/95] VENT
* [IP01545(B F )02/95] Use VENT to bring outside air through the
instrument panel registers. You can heat the air
in this position by rotating the temperature knob
into the RED area. The air CANNOT be cooled
below the outside temperature regardless of the
temperature knob setting.
* [IP01550(B F )03/95] FLOOR
* [IP01555(B F )05/94] Air flow will be to the floor when FLOOR is
selected. The air can be heated by rotating the
temperature knob into the RED area.
* [IP01560(B F )03/95] MIX
* [IP01563(B F )05/94] Select MIX to get air to the floor and windshield
defrosters at the same time.
* [IP01565(B F )03/95]
V DEF
* [IP01570(B F )04/95] Select V DEF to obtain maximum air flow to
the windshield. Rotate the temperature knob into
the RED area for the air temperature required to
defrost. Rotate the
H knob to increase or
decrease the air flow.
* [IP01575(B F )05/94] Operating Tips
* [IP01580(B F )02/95] The following tips will help you to get the most
satisfaction from your heater system.
[IP01585(B F )04/95]
❑ In humid weather, select V DEF. This will
help to prevent windshield fogging. After a
few minutes, you may select another airflow
position.
* [IP01587(B F )02/95]
❑ To prevent humidity buildup inside your
vehicle, always drive with the heater system
turned on.
File:ltipf.ex
Update:Thu May 9 15:21:29 1996