FOCUS Enhancements FS-2/2E - Manual (Page 14)

FS-2 and FS-2E Studio DTE Disk Recorders User Guide
1 - 3
Part Number: MANL-0927-03
INTRODUCTION
One (1) FireStore FS-2/2E unit with
attached rack mounting ears
One (1) 120GB IDE disk drive in caddy
One (1) 6-pin to 6-pin FireWire cable
(for External Drive connection)
One (1) 6-pin to 6-pin FireWire cable
(for front panel port loop)
One (1) User Guide
One (1) Focus Enhancement's
Warranty Card and Statement
One (1) Focus Enhancement's
FireStore DV Conversion Suite Demo
Disk
If any of these menus are missing, contact Focus
Enhancements or your FireStore dealer/distributor
immediately.
You may need to purchase cables to connect more
than one hard disk drive to the FS-2/2E at a time.
Your Focus Enhancements dealer can help you
identify additional cables you may need.
Installation and
Site Requirements
Focus Enhancements recommends that FS-2/2E
units be installed in a restricted access area, such
as an equipment room or closet and the installation
be performed by trained installers.
The units are designed and tested to operate
reliably between +5 - +40C (41 - 104 F).
To maintain this range, consider the following:
Air temperature surrounding the
equipment must remain within the
specified range.
Air flow around the equipment must be
sufficient to maintain proper operating
temperatures
If in doubt about the site temperature, take
measurements to be certain. If measured
temperatures fall outside the defined ambient
temperature range, you must bring the temperature
within the defined range.
Storage temperature for the units must remain
between -20 - +60C (-4 - 140 F).
Mounting in a 19” Electronics
Rack
The FS-2/2E measures 15.89” high x 17.36” wide
by 3.47” deep. It is an 2RU chassis featuring front
rack mount ears to be installed into a standard 19”
audio/visual rack. There must be room behind the
unit for the attachment of cables.
To mount the FS-2/2E in a standard 19” audio/
visual rack, do the following:
S TEP 1: Determine the desired location. The
FS-2/2E requires 3.47 vertical inches
of rack space.
To prevent overheating, the FS-2/2E
requires a minimum of 1.75 vertical
inches of space above and below the
unit.
S TEP 2: The FS-2/2E includes a pair of
universal mounting ears on the front
sides of the unit that support standard
19” audio/visual racks. Using the
provided hardware, mount the FS-2/2E
securely in the rack.
S TEP 3: Connect the FS-2/2E unit to the wall
current using the attached power cord.
Inserting the Internal 3.5” IDE
Drive
Insert the internal 3.5” IDE drive as follows:
S TEP 1: Remove the drive from its packaging.
S TEP 2: Slide the drive carefully into the bay
until it is seated firmly.
Screws
Screws