FOCUS Enhancements FS-2/2E - Manual (Page 53)

FS-2/2E FUNCTIONS
FS-2 and FS-2E Studio DTE Disk Recorders User Guide
2 - 32
Part Number: MANL-0927-03
When an unknown volume type (HDD) is connected
to the FS-2/2E, the Partition process puts a FAT32
format onto the drive. It erases any previous
partition and data.
Select YES and a progress message appears on
the screen.
NOTE: You cannot add multiple partitions an a
single drive using the FS-2/2E.
With drives greater than 128G, the FS-2/2E creates
multiple partitions. There will be a partition for each
128G of disk space available.
Repair
When you make this selection, the following screen
appears:
Select the desired function.
Press SEL to make a selection.
Press EXIT to return to the menu
screen.
CHECK DISK
This selection scans the entire volume for any
errors (usually, if a file was corrupted during a
recording, check disk alerts you of this).
CURRENT CLIP
This selection performs a similar function, but on
the selected clip only. If an error is found, the
FS-2/2E prompts you to repair the problem.
CURRENT CLIP repairs the last file in the current
session if it has been damaged.
Select between volumes by pressing the and
buttons. Press EXIT to return to the menu
screen.
File Name
When you make this selection, the following screen
appears:
This selection displays the base file name of the
selected clip.
Factory Reset
When you select this function, the FS-2/2E reverts
all settings and values back to its factory default
state.
Press YES to start factory reset.
Press EXIT or NO to exit from the
menu.
Warning: Factory Reset is not un-doable!!!
Diagnostic
When you make this selection, a screen similar to
the following appears:
This is a setting used for diagnosing field issues. Do
not change it unless told to by Focus
Enhancements Technical Support.
CHECK DISK
CURRENT CLIP
EXIT SEL
CLIP 1-001
BASE:
:
20010612-166523
EXIT
DIAG LVL: 00
EXIT