FOCUS Enhancements FS-2/2E - Manual (Page 60)

FS-2 and FS-2E Studio DTE Disk Recorders User Guide
3 - 7
Part Number: MANL-0927-03
Using the FS-2/2E
How to Mark Scenes
The FS-2/2E Scene Marking feature allows you to
mark clips for placement in particular folders during
recording, playback or stop mode.
When a drive is formatted using FireStore, ten
folders are created numbered 0 through 9. After the
drive is formatted on FireStore, you can connect the
hard-disk drive to a computer and give each of
these folders a custom name (if you need help
mounting your FireWire hard-disk drive to your
computer system, refer to “How to Put Recorded
Clips on a Computer System” on page 2-2. To
rename each folder, click on the folder name until it
is highlighted, then type in the desired name of the
folder.
NOTE: Folder names cannot exceed eleven
characters.
Folders are ordered on FireStore in numerical
followed by alphabetical order. For instance, if
folders are named “Scene 1”, “Scene 2” and
“Auditions”, they appear on FireStore as “1
Auditions”, “2 Scene 1” and 2 Scene 2”. The folder
number is added in front of the folder name on the
FS-2/2E LCD display for easy identification when
using the optional remote control commander
keypads.
To create a custom order to Folders, Focus
Enhancements recommended that you change the
name to change the numerical/alphabetical order.
For example place numbers at the beginning of the
folder name to determine the key to folder
assignments.
After you have selected your “mark to” folder, you
are almost ready to mark your scenes. Before you
can start marking, you must select the playlist that
will contain your scenes. To do this, use the
following steps:
S TEP 1: Press the PLAYLIST button to bring up
the playlist menu.
S TEP 2: Select either OPEN, to choose an
existing playlist, or NEW, to create a
new one.
S TEP 3: Exit the PLAYLIST menu by pressing
the MENU button
Now you are ready to mark your scenes. Use the
following procedure:
S TEP 1: Play your pre-recorded clip from the
FS-2/2E.
S TEP 2: When you encounter the start of your
scene, pause the FS-2/2E and then
press the MARK IN button. The MARK
IN button should light up.
S TEP 3: Play your clip again to the end point
and pause.
S TEP 4: Press MARK OUT. The MARK OUT
button lights.
S TEP 5: Press the PLAYLIST button to save the
marked scene.
S TEP 6: Mark the rest of your scenes using the
same procedure.
S TEP 7: When you have completed marking
your scenes, you must save the playlist
to disk. Stop the playback on the
FS-2/2E and press PLAYLIST.
S TEP 8: Select the SAVE menu option, enter
the playlist name.
S TEP 9: Press NEXT, and then press YES to
confirm your request to save the
playlist. The playlists are saved in the
PLAYLIST folder on your hard drive.
Advanced users can delete or change the order of
scenes using the PLAYLIST->EDIT menu options.
For FS-2E users, or FS-2 (with 2.0 upgrade), you
can also use the web interface (shown below) to
edit the current playlist. Use your browser to
connect to the FS-2E, and select the PLAYLIST
tab.