Furuno FCV-30 - Manual (Page 13)

1. OPERATIONAL OVERVIEW
1-3
3. Change settings as appropriate, referring to the information below.
4. After changing settings, roll the trackball to place the pointer on the OK button and then
push the left button to save settings and close the dialog box. (See Note 3 below.)
Note 1: To restore previous settings, click the Cancel button instead of the OK button at
step 4.
Note 2: To see the result of a change without closing a dialog box, click the Apply button.
Note 3: Unless otherwise noted, the phrase “click…” means to click the object with the left
mouse button.
Changing setting using radio buttons
Enabled Disabled
Radio buttons
Click the item desired. A black dot appears when the item selected is enabled.
Changing setting using a list box
Normal
List box
1. Click ▼ in the list box or click the box itself to show a list of options.
2. Click the desired setting.
Changing setting using a spin box
Spin box
A setting may be changed from a spin box two ways depending on contents of the spin box:
1) Click ◄ or ► successively in the spin box to choose the setting desired. Each click
increments the setting downward or upward depending on arrow clicked.
2) Spin the thumbwheel to choose value with the cursor.
Cursor
Spin box
Place the pointer on the “tenkey” button ( ) at the lower left-hand corner and then push the
left button to show the tenkey panel.