Freedom9 FREEVIEW 80 User Manual
Page 11
Advertising
freeView Power 80 User Manual
9
15. Configure the third unit’s ID number to “3” by logging into the web GUI, going to the RPM
Setting menu, select “RPM00” under Select RPM, then select “03” beside “Address Change”
then click “Apply”. After changing the unit’s ID number, you will see the LED beside the
number 3 light up on the front panel of the third unit.
Figure 8 - First Three Units Connected with iLink Cable
For configurations with more than three units, repeat steps 10-15 for the remaining units.
Advertising