Freedom9 FREEVIEW 80 - Manual (Page 35)

freeView Power 80 User Manual
33
4.4.3 Changing the Password
To change the password, follow these steps:
• Enter the command “888#” after logging in.
• You will hear long beeps indicating that the device is ready to change your password.
• Enter a new password using the following pattern: 888XXXXXXXXXX#. The password
(XXXXXXXXXX) must be between 7 and 10 numbers. Enter “888” first, and then enter the
new password, and press the “#” key when finished.
• You will hear two short beeps confirming the unit received your entry.
• Reenter the password using the same format as above to confirm the password.
• You will hear four short beeps confirming that the password has been changed.
4.4.4 Recovering the Password
If you forget the password for the device, follow these steps to reset the password to the default
(123456789).
Dial the phone number of the freeView Power 80.
After three rings, the unit will answer with two short beeps.
Press and hold the “A” and “H” buttons on the freeView Power 80 simultaneously within 20
seconds.
When the “A” and “H” LEDs start blinking, release the two buttons.
You will hear four beeps on the telephone, and the password will have been reset to default.
4.4.5 Telephone Pass-through
An analog telephone can be connected to the second telephone port on the unit, and can be
used as a standard telephone for inbound and outbound calls as long as the freeView Power 80
is not using the line. For inbound calls, the freeView Power 80 will automatically answer the call
after three rings.