Freedom9 FREEVIEW 80 - Manual (Page 31)

freeView Power 80 User Manual
29
Figure 33 – Event Log Page
The possible events for the freeView Power 80 are:
• RPM Connection Lost: One of the freeView Power 80 units in the stack is unavailable.
• Outlet On: A specific outlet has been turned on.
• Outlet Off: A specific outlet has been turned off.
• Outlet Reboot: A specific outlet has been rebooted.
• Outlet Fault: A specific outlet is defective.
With the freeView Power M2 module, the following events can occur:
• Environmental Temperature Overrun: The environment sensor reported a temperature level
above the maximum allowable temperature level.
• Environmental Temperature Underrun: The environment sensor reported a temperature level
below the minimum allowable temperature level.
• Environmental Humidity Overrun: The environment sensor reported a humidity level above
the maximum allowable humidity level.
• Environmental Humidity Underrun: The environment sensor reported a humidity level below
the minimum allowable humidity level.
4.2.15 Save Event Log
Clicking on the Save Event Log link will allow you to download the current event log to your
computer in comma delimited format.
4.3 Telnet
To connect to the freeView Power 80 using Telnet, follow these steps:
1. In Windows, click the Start Menu, then click “Run…” (Figure 34)
2. Type in “telnet <ip address>” where <ip address> is the IP address of the freeView Power
80.