GE 49-8549 - Manual (Page 35)

2. Aluminum
A. Connect length building wire to
terminal block.
copper wires to aluminum wiring using
special connectors designed and approved
for joining copper aluminum, and follow the
connector
recommended
procedure closely.
used, location and enclosure of
splices, must conform to good wiring
practice and codes.
STEP
SYSTEM
SPECIAL GROUNDING INSTRUCTIONS
WARNING:
grounded to neutral of appliance
through a link. If in a MOBILE HOME or
if LOCAL not permit grounding
through the neutral:
1) disconnect the link from neutral,
use grounding terminal or lead to ground
unit in accordance with local codes, and
connect terminal
0 1
- to branch
circuit in usual manner.
appliance is to be connected
means a set, use cord
for this p
CO
LUG
STEP
BRACKET INSTALLATION
bracket is supplied with instructions
for installation in locations. The
instructions include a template, parts and a
tools necessary’ to installation.
Read IMPORTANT INSTIKJCTIONS
the instructions that fit your situation
WARNING
1. Range must be secured by ANTI-TIP bracket
supplied.
2. See instructions to install (supplied with
bracket).
3.
properly installed, range could be
tipped by stepping or sitting on door. Injury
might result from spilled hot liquids or from
range itself.
Typical installation of Anti-Tip bracket
Attachment to Wall
Bracket
STEP 7
LEVELING THE RANGE
The range must be level. Leveling feet are located
at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rotate the
feet in and out as required to the
range. (For instructions on how to remove and
replace the storage drawer or the kick panel, see
the Cleaning
the Range section in Care
and Cleaning.) On some models, there are
covers which may be removed for easy
adjustment (just squeeze and pull).
One the rear leveling feet will engage the
ANTI-TIP bracket (allow for some side to side
adjustment). Allow a minimum clearance of
inch between the range and the leveling foot that
is to be installed into the ANTI-TIP bracket.
Check the range for proper installation into the
ANTI-TIP bracket (after the range has been
properly installed) by removing the kick panel or
storage drawer and inspecting the rear leveling
Make sure it fits securely into the slot.
STEP 8
FINAL
Be sure all switches are in the
position
before leaving the range.
35