GE 49-8549 - Manual (Page 29)

Proper care and cleaning are important so your range will give you efficient
and satisfactory service. Follow these directions carefully in caring for it to
help assure safe and proper maintenance.
BE SURE ELECTRIC POWER IS OFF BEFORE CLEANING ANY PART
OF THE RANGE.
A If your range is removed for cleaning, servicing or any reason,
be sure anti-tip device is re-engaged properly when the range
is replaced. Failure to take this precaution could result in tipping of
the range and cause injury.
Oven Light Replacement
(on some models)
CAUTION: Before replacing your oven light bulb, To replace cover:
disconnect the electrical power to the range at the
1. Place into groove the receptacle. Pull
main fuse or circuit breaker panel. Be sure to let
the light cover and bulb cool completely.
wire forward to the center until it
into place. When in place. the wire holds the
The is covered with a removable glass firmly. certain the wire is in the depression in
cover that is held in with a bail-shaped wire. the center of the cover.
door, if desired, to reach cover easily.
2. Connect electrical power to the
To remove:
1. Hold a hand under the
cover so it doesn’t when
released. With fingers of’ the
-/ ‘
same firmly push back
wire holder. Lift off
~\
-_
.
the Wire cover holder
NOT ANY SCREWS TO
COVER.
2. Do not touch hot bulb with a wet cloth. Replace
bulb with 40-watt household appliance