GE Industrial Solutions Entellisys System Administrator Manual - Manual (Page 11)

11
3
3 Commissioning the switchgear
Installing and starting up the switchgear is an important event for the System Administrator. The
following steps must be followed when commissioning the switchgear.
• Step 1: Reset Passwords.
See Passwords on page 13 .
• Step 2: Set User Settings.
See DEH-231 Entellisys Low Voltage Switchgear System User Manual.
• Step 3: Set Local HMI flags.
See Local HMI on page 17 .
• Step 4: Set System Time Synchronization.
See Time synchronization on page 19 .
• Step 5: Configure System for Remote Communications.
See Configuring the switchgear for remote communications on page 21 .