GE Industrial Solutions Entellisys System Administrator Manual User Manual
Page 51
Advertising
Part II – Replacing the CPU
51
12
• Apply power to the new CPU and allow 2 minutes for the device to self-initialize prior to
performing Step 4. If the new CPU is known to already have an IP address as specified in the
Step 4 dialog box, select the Skip This Task check box prior to clicking Next. Otherwise, leave
the check box cleared and just click Next.
Figure 12-10 Step 4 – Set Original IP dialog box
• A confirmation dialog box will display asking for confirmation that the old CPU has been
replaced and the new CPU is installed and has been powered on for at least 2 minutes.
Figure 12-11 Entellisys LVS HMI dialog box
Advertising