Grizzly G0501 - Manual (Page 19)

G0501 Sliding Table Saw -17-
Main Crate:
• Saw Base Unit
• Blade Guard
• Blade Guard Lower Support Arm
• Blade Guard Upper Support Arm
• Blade Guard Swing Arm
• Push Stick
• Large Extension Table
• Large Extension Table Braces (2)
• Small Extension Table
• Small Extension Table Braces (2)
• Crosscut Table
• Riving Knife
• Rip Fence Rail
• Rip Fence Clamp
• Tool Box
—Feet (4)
—Foot Studs (4)
—Combo Arbor Wrench 30, 36 MM
—Combo Wrench 22, 24 MM
—10 pc Hex Key Set
—6 pc Combo Wrench Set
—Arbor Locking Tool
Fence Crate:
• Sliding Table
• Crosscut Fence
• Extruded Aluminum Rip Fence
• Miter Fence
• Long Crosscut Table Brace
• Short Crosscut Table Brace
• Sliding Table End Handle
• Sliding Table End Cap
• Flip Stop w/Indicator on End
• Flip Stop w/Indicator in Middle
• Sliding Table Rail Handle
• Bar w/Scale
• Flat Head Screws (4) M6-1.0 x 30
The Model G0501 is shipped from the manufac-
turer in a carefully built crate. If you discover the
machine is damaged after you have signed for
delivery,
please immediately call Customer
Service at (570) 546-9663 for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the con-
dition of your shipment, you should inventory the
equipment from the shipping crate.
The purpose of this section is to guide you
through the required steps to get your machine
out of its crate and into operating condition.
Wear safety glasses dur-
ing the entire set up
process!
This machine presents
serious injury hazards
to untrained users. Read
through this entire man-
ual to become familiar
with the controls and
operations before start-
ing the machine!
Piece Inventory
Unpacking
About this Section
SECTION 5: SET UP