Grizzly G0501 - Manual (Page 44)

-42- G0501 Sliding Table Saw
Figure 71. Crosscutting workpieces
using the rip fence as a cut-off gauge.
Lastly, this machine has the capability of cross-
cutting workpieces while using the rip fence as a
cut-off gauge (Figure 71).
Determine which cutting operation will be best
suited for the workpiece to be crosscut.
— If you will be crosscutting full size panels,
then skip ahead to “Crosscutting full size
panels.”
— If you will be crosscutting smaller panels,
then skip ahead to “Crosscutting smaller
panels.”
— If you will be crosscutting workpieces
using the rip fence as a cut-off gauge,
then skip ahead to “Crosscutting using
the rip fence as a cut-off gauge.”
Figure 70. Crosscutting smaller panels.
Figure 69. Crosscutting full size panel.
With the crosscut fence mounted in the forward
position (Figure 69), the Model G0501 has the
capability of crosscutting full size panels.
With the crosscut fence mounted in the rear posi-
tion (Figure 70), this machine also has the capa-
bility of crosscutting smaller panels.
Crosscutting
Forward Mounted
Crosscut Fence
Rear Mounted
Crosscut Fence